I´m not sure if I have some weired project setting, but the following issue if driving me nuts:
1.) I have two open document - lets say ClassA.m & ClassB.m - and I am working in ClassA.
2.) Jump to a Definition of ClassC (via CMD+Klick).
3.) Now I have three open Documents. The Order is: ClassA, ClassC, ClassB
4.) Close ClassC (via CMD+W)
5.) ClassB has the Focus. And this is driving me crazy ;-)
I would like to be in ClassA again.
Is there a possibility to adjust this in the settings!?
Thanks for feedback!